Funky Charm Bracelet

Requirements

This pattern is designed for a young girl with a small wrist.  If making it for an adult 2 packets of Charms will be required.

1 Packet of the following:

• Ribtex Jewellery Bitz Charms Hearts/Butterfly/Dragonfly (eg CHM105)
• Ribtex Jewellery Bitz Ball Beads (eg CHM209)
• Ribtex Jewellery Bitz Dragonfly Charm Connector (eg CHM210)
• Ribtex Jewellery Bitz Small Jump Rings (eg JF114)
• Ribtex Funky Beadz Two Tone (eg FB003)
• Ribtex 0.5mm Stretch Thread - Clear (eg ST05CL)

Instructions

Take two lengths of Stretch Thread (approximately 30cm).

Thread 1 x Bead, 1 x Ball Bead, 1 x Bead, 1 x Connector onto the stretch thread.  Repeat this pattern 5 more times until a total of 6 Connectors are on the Stretch Thread.

Wrap around wrist to see if a longer bracelet is required.  If so repeat the pattern one more time.

Tie the Stretch Thread together very firmly with a secure knot.  Cut off loose ends.

Open the Jump Rings with a set of pliers.  Thread the Jump Ring through the loop on the Connector adding a Charm to each ring before closing with pliers.  Make sure all of the Charms are facing upwards before you close the jump ring.  Repeat the process until all Charms are in place on the bracelet.