Flight of Fantasy
Requirements
- 1 pack Ribtex Oval Glass Beads Black (OGB102)
- 1 pack Ribtex Glass Sharks Teeth Amber (GB625)
- 1 pack Ribtex Jewellery Bitz Open Link Chain Medium Bohemian Gold (JF328)
- 1 pack Ribtex Jewellery Bitz Feather Bohemian Gold (JF396)
- 1 pack Ribtex Jewellery Bitz Toggle Bohemian Gold (JF412)
- 1 pack Ribtex Jewellery Bitz Jump Rings Small Bohemian Gold (JF270)
- 1 pack Ribtex Jewellery Bitz Head Pins Bohemian Gold (JF272)
- 1 pack Ribtex Jewellery Bitz Eye Pins Gold (JF149)
- Access to a set of Ribtex Cutter Pliers (JF165)
- Access to a set of Ribtex Round Nose Pliers (JF166)
Instructions
1. Cut three pieces of open link chain to the following lengths; 1 x 7cm, 1 x 9cm, and 1 x 11cm.
2. Join remaining long length of chain (approximately 73cm) with a jump ring. Attach toggle bar to the same jump ring.
3. Thread an oval glass bead onto a head pin. Leaving approximately 1cm, trim excess wire and form a loop at the end of the pin. Repeat to make 3 oval dangles.
4. Thread an eye pin through the hole at the top of a sharks tooth. Using the straight end twist the pin ends together, creating a loop to attach to the chain. Trim excess wire. Repeat to make 6 pieces.
5. Attach oval dangles and sharks teeth to the short lengths of chain as shown.
6. Attach feathers to the short lengths of chain using small jump rings as shown.
7. Connect the short chain lengths to the toggle ring using a small jump ring.
8. Connect 4 feathers to the necklace chain (2 on either side of the toggle).
9. Hook toggle bar into toggle ring.
Your Flight of Fantasy is complete.
Links and Downloads
|
