Glass Charm Bracelet

Requirements

1 Packet of the following:

• Ribtex Jewellery Bitz Charms Hearts/Butterfly/Dragonfly (eg CHM105)
• Ribtex Jewellery Bitz Bead Caps 10mm (eg CHM202) 
• Ribtex Jewellery Bitz Dragonfly Charm Connector (eg CHM210)
• Ribtex Jewellery Bitz Small Jump Rings (eg JF114)
• Ribtex 6mm Glass Beads (eg GB103)
• Ribtex 10mm Glass Beads (eg GB301) 
• Ribtex 0.5mm Stretch Thread - Black (eg ST05BK)
• Access to a set of round nose pliers (eg JF166) 

Instructions

Take two (for additional strength use three) lengths of Stretch Thread (approximately 30cm).

Thread 1 x Bead Cap, 1 x 10mm Glass Bead, 1x Bead Cap,  1 x 6mm Glass Bead, 1 x Dragonfly Charm Connector and 1x 6mm Glass Bead onto the lengths of stretch thread.  Repeat this pattern 5 more times until a total of 6 Connectors are on the stretch thread.

Wrap around wrist to see if a longer bracelet is required.  If so repeat the pattern one more time.

Tie the Stretch Thread together very firmly with a secure knot.  Cut off loose ends.

Open the Jump Rings with a set of pliers.  Thread the Jump Ring through the loop on the Connector adding a Charm to each ring before closing with pliers.  Make sure all of the Charms are facing upwards before you close the jump ring.  Repeat the process until all Charms are in place on the bracelet.

To increase the range of charms on a bracelet, mix and match across the Ribtex Charms Range.

Links and Downloads

Charm Bracelet Project Sheet PDF download, Charm Bracelet Project Sheet 353Kb Download...