Gypsy Waterfall
Requirements
- 1 pack Ribtex Lamwork Bead Oval Sputnick Red (LWB102)
- 1 pack Ribtex Oval Glass Beads Red (OGB103)
- 1 pack Ribtex 8mm Cat's Eye Beads Rust (CAT305)
- 1 pack Ribtex Jewellery Bitz Open Link Chain Small Bohemian Gold (JF333)
- 1 pack Ribtex Jewellery Bitz Split Ring 15mm Bohemian Gold (JF359)
- 1 pack Ribtex Jewellery Bitz Jump Rings Bohemian Gold (JF270)
- 1 pack Ribtex Jewellery Bitz Head Pins Bohemian Gold (JF272)
- 1 pack Ribtex Jewellery Bitz Shark's Teeth Bohemian Gold (CHM402)
- 1 pack Ribtex Jewellery Bitz Rings Bohemian Gold (CHM403)
- Access to a set of Ribtex Cutter Pliers (JF165)
- Access to a set of Ribtex Round Nose Pliers (JF166)
Instructions
1. Cut 3 pieces of open link chain to the following lengths; 1x 7cm, 1 x 8cm, and 1 x 11cm.
2. Join the remaining length of chain together. Find the centre and connect to the large split ring.
3. Connect a jump ring to each of the 10 large rings.
4. Connect a jump ring to each of the 3 shark's teeth.
5. Thread 4 red glass oval beads, 5 rust cat's eye beads and 3 red lampwork beads onto head pins. Leaving approximately 1cm, trim excess wire and form a loop at the end of the pin using round nose pliers.
6. Attach the various beads and large rings onto the short chain lengths as shown.
7. Connect the short chain lengths to the large split ring.
8. Connect 6 large rings to the necklace chain, three rings on each side of the centre split ring spaced evenly as shown.
Your Gypsy Waterfall is now complete.
Links and Downloads
|
