Pearl Elegance
Requirements
- 1 pack Ribtex Glass Pearls 10mm White (GPL404)
- 1 pack Ribtex Glass Pearls 4mm White (GPL104)
- 1 pack Ribtex Glass Bi-cone 6mm AB Crystal (GB107)
- 1 pack Ribtex Glass Discs Crystal (DSK106)
- 1 pack Ribtex Jewellery Bitz Eye Pins Silver (JF150)
- 1 pack Ribtex Jewellery Bitz Thick Necklace Chain Silver (JF176)
- 1 pack Ribtex Jewellery Bitz Flat Link Necklace 60cm (JF336)
- Access to a set of Ribtex Cutter Pliers (JF165)
- Access to a set of Ribtex Round Nose Pliers (JF166)
Instructions
This elegant necklace combination is made up of two separate necklaces.
Chunky Chain with Pears and Bi-cones
1. Undo the lobster clasp on the flat link necklace (JF336). Measure 15cm from either end of the chain (one length will include the lobster clasp and one length will include the connecting jump ring) and cut 2 x 15cm lengths of chain.
2. Cut the remaining flat link necklace chain into 3 x 9cm pieces. Set all chains aside.
Construct pearl units as follows:
3. Thread beads onto an eye pin in the following order; 
- 4mm glass pearl
- 6mm bi-cone
- 10mm glass pearl
- 6mm bi-cone
- 4mm glass pearl
Leaving approximately 1cm, trim excess wire and form a loop at the end of the pin. Repeat to make 4 units.
4. Attach the eye pins to the short sections of chain to complete the necklace.
Fine Chain with Glass Discs
1. Cut thick necklace chain (JF176) into 4 x 9cm lengths and 1 x 40cm length.
Construct pearl and discs units as follows:
2. Thread beads onto an eye pin in the following order;
- glass disc
- 10mm glass pearl
- glass disc
Leaving approximately 1cm, trim excess wire and form a loop at the end of the pin. Repeat to make 5 units.
3. Attach the eye pins to the end of the short sections of chain to complete the necklace.
Your Pearl Elegance is complete.
Links and Downloads
|
