Elegant Lariat

Click on image to view larger version.

What you will need

> 1 x TH101 - Ribtex Simulated Leather Thonging Black
> 1 x GPL204 - Ribtex Glass Pearls 6mm White
> 1 x GPL504 - Ribtex Glass Pearls 12mm White
> 1 x SWK101 - Ribtex Swarovski Crystal Bicones 4mm Crystal AB
> 1 x JF548 - Ribtex Diamante Rondelle 8mm Silver
> 1 x JF183 - Ribtex Head Pin Silver
> 1 x JF114 - Ribtex Jump Rings 4mm Silver
> 1 x JF246 - Ribtex Leather Clamps 12mm Silver

Access to Ribtex Cutting Pliers (JF165), round Nose Pliers (JF166) and Scissors

Let's Get StartedElegant Lariat

Step 1
Attach a leather clamp to either end of a 1m length of simulated leather thonging.  Do this by placing the end of the thonging into the open clamp with the loop of the clamp facing towards the outside.  Then close one side of the clamp over the thonging using the cutting pliers.  Then close the opposite side of the clamp over the first side.

Step 2
Thread the following beads onto a head pin: a 4mm bicone, a 6mm pearl, a 4mm bicone, a 12mm pearl, a 8mm rondelle and 6mm pearl.  Cut off excess pin, leaving approximately 7mm.  Turn the excess pin into a loop using round nose pliers.  Use a jump ring to attach the beaded unit to the end of the leather clamp.

Step 3
Thread the following beads onto a head pin: 4mm bicone, 8mm rondelle and a 4mm bicone.    Cut off excess pin, leaving approximately 7mm.  Turn the excess pin into a loop using round nose pliers.  Use a jump ring to attach the beaded unit to the end of the second leather clamp.

Your Elegant Lariat is complete!