Turquoise Ring Necklace

Click on image to view larger version.

What you will need

> 1 x GB612 - Ribtex Glass Chunks Solid Turquoise
> 1 x JF578 - Ribtex Diamond Spacers 10mm Bright Silver
> 1 x JF557 - Ribtex Feature Plastic Ring Round 16mm Bright Silver
> 1 x JF560 - Ribtex Feature Plastic Ring Round 20mm Bright Silver
> 1 x JF600 - Ribtex Spacer Round 4mm Bright Silver
> 1 x JF112 - Ribtex Jump Rings 7mm Silver
> 1 x JF150 - Ribtex Eye Pins 35mm Silver

Access to Ribtex Cutting Pliers (JF165) and Round Nose Pliers (JF166)

Let's Get Started

Step 1
Create the Turquoise Bead Units.  Thread a 4mm spacer onto an eye pin followed by a turquoise chunk and another 4mm spacer.  Cut the excess off the eye pin, leaving approximately 7mm of pin.  Turn the end of the eye pin into a loop using your round nose pliers.  Repeat to create nine Turquoise Bead Units in total.

Step 2
Create the Diamond Spacer Units.  Thread a 10mm diamond spacer onto an eye pin.  Cut the excess off the eye pin, leaving approximately 7mm of pin.  Turn the end of the eye pin into a loop using your round nose pliers.  Repeat to create six Diamond Spacer Units in total.

Step 3
Assemble the necklace by connecting all of the units together using jump rings.  The first section joins the small and large rings together to form a chain.  Start with a 20mm ring, then a jump ring, then a 16mm ring and a  jump ring, continue alternating the large and small rings until you have attached 6 x 20mm rings.

Step 4
Next attach the bead units in the following sequence; diamond spacer unit, jump ring, turquoise bead unit, jump ring, turquoise bead unit, jump ring, turquoise bead unit, jump ring and a diamond spacer.

Step 5
Continue with the chain sequence from step 3 until you have 3 x 20mm rings.

Step 6
Now repeat the bead sequence from step 4.

Step 7
Repeat the Chain sequence from step 5.

Step 8
Repeat the Bead sequence from step 4 connecting the last diamond spacer unit to the first 20mm ring to complete your necklace.

Wear with pride!