Twist of Colour Bracelet

Click on image to view larger version.

Twist of Colour Bracelet

What you will need:

> 1 x GB910 - Ribtex 4mm-8mm Glass Beads with Metallic Stripe Cobalt 50pcs
> 1 x JF212 - Ribtex Memory Wire Bracelet Size 25g
> 2 x JF936 - Ribtex Curved Tube 50mm Bright Silver 6pcs
> 1 x JF351 - Ribtex Head Pins 35mm Silver 20pcs

Access to Ribtex Cutting Pliers (JF165) and Ribtex Round Nose Pliers (JF166)

Let's get started:

1.  Cut a length of memory wire 55cm long (approx 6 loops).

2.  Using Round Nose Pliers, turn one end of the memory wire into a small loop.  This will prevent your beads from sliding off as you thread them onto the memory wire.

3.  Thread a head pin with one of the largest beads.  Cut the excess off the head pin, leaving approximately 7mm of pin.  Turn the end of the head pin into a loop, and link through the loop at the end of the memory wire before closing completely.

4.  Thread the memory wire with two of the 4mm beads, followed by a 6mm bead and them an 8mm bead, followed by a curved tube.  Repeat this process 8 times.

5.  Finish with one 6mm and one 4mm bead.  Trim excess memory wire to approximately 7mm and then form a small loop to secure the beads in place.

6.  Place two 6mm beads and two 4mm beads onto another head pin.  Cut the excess off the head pin, leaving approximately 7mm of pin.  Turn the end of the head pin into a loop, and link through the loop at the end of the memory wire before closing completely.

7.  Your bracelet is complete!